What to pay attention to when operating and using laser cutting equipment

Nowadays, many industries use laser cutting equipment, and this type of equipment requires professional training before operation because it is very precise. There are also many points to pay attention to in daily use. It is necessary to pay attention to the maintenance of the equipment at all times, and today I will talk about it. What should be paid attention to when using laser cutting equipment.

• First, there are many operations and maintenance items that need to be paid attention to when using laser cutting equipment. Among them, the cooling water must be replaced according to the equipment requirements. In most cases, it is changed every month, and the movement takes three months. Perform a replacement, depending on the frequency of use. It should be noted that the cooling water must be drained and replaced with new cooling water. If the equipment has a designated brand of cooling water, the designated brand must be used. Not paying attention to these leads to cold water. The consequences of machine blockage are serious.
• Second, when using laser cutting equipment, you should also pay attention to the gas situation. For example, high-pressure liquid oxygen must be used for oxygen and a vaporizer must be added, so that the liquid oxygen can be raised to a normal temperature gas state, and the oxygen should be paid attention to. The pressure on the pipe should be 4.5MPA, and the purity of the oxygen should not be lower than 99.6%, and to avoid transportation pollution, the welded pipe must be cleaned before use. Similarly, pay attention to the nitrogen and air conditions.
• Third, do not use oxygen to replace the air driving the cylinder when using laser cutting equipment, because when oxygen is introduced into the pipe of the exchange table cylinder, sparks will occur during the operation of the equipment and the air pipe will be burned, and the air pressure in the driving cylinder must not be less than 1MPA, otherwise the trachea will burst open because it cannot withstand the pressure.

What I just mentioned is what you need to pay attention to when using and operating laser cutting equipment, and because there are many types of laser cutting equipment, you should also understand these problems according to the specific model, so as to ensure the normal operation of the laser Cutting Machine And reduce the failure rate, but also extend the service life of the equipment.